NL | EN | DE


Directions for use: Cuglaton

colorcode

Pre-treatment

The surface on which CUGLATON is to be applied must be clean. If possible, remove any cement skin. No free water may be present.


Pre-treatment with water

The surface only has to be moistened with water in advance (NB: no free water may be present).

Or:

Pre-treatment with CUGLACRETE hechtprimer cementgebonden or CUGLACRETE hechtprimer epoxy sealer.

For optimal binding, we recommend using CUGLACRETE hechtprimer cementgebonden (a modified polymer adhesive system), or CUGLACRETE hechtprimer epoxy sealer (an epoxy resin adhesive system).

Mixing

Cuglaton machinaal mengen tot een homogeen mengsel. Mengtijd afhankelijk van het type menger, ca. 3 minuten.

Water quantity

Water range: see front of bag. Add as much water as possible within the specified range to achieve a consistency in line with the type of mortar being used without any bleeding.

Processing information

Processing time 30 minutes, at 20 °C
Ambient temperature minimum 0 °C, maximum 30 °C
Temperature of the surface > 0 °C

Post-treatment

The finished surface must be carefully protected against drying out with Cugla Curing Compound, or covered with plastic sheeting.

Storage

Store in a dry place

 

Cugla BV | PO Box 3477, NL-4800 DL Breda Rudonk 11, NL-4824 AJ Breda Netherlands | +31 76 541 06 00 |